|
Post by admin on Jan 3, 2004 13:10:59 GMT -5
Here is a hardware set from Autograph the makers of the Ferrari F40 superdetail kit. Contains over 1000 screws and bolts. Whew. ;D So let's see 1500 or so parts in SMS's kit plus another 1000 bolts and nuts..... www.scaleautoworks.com/hardwareset.htmTim Corn
|
|
ffracer
New Member
Paul Smith
Posts: 22
|
Post by ffracer on Jan 6, 2004 7:35:49 GMT -5
From what I could see, this is essentially a kit consisting of Jeweler's screws which really aren't very accurate. If you have the $175 to spend, go stock up on some RB Motion stuff. It is really accurate and will give results that are a lot better. This is the route I am taking on my 935.
Paul
|
|
|
Post by admin on Jan 6, 2004 9:30:38 GMT -5
Thanks Paul and welcome! I did a little digging on the internet and found the RB Motion catalog. Looks like great stuff. I'll post some scans later for anyone looking to order parts.
Any suggestions on sizes for bolt heads and other parts that are useable on the 935? Thanks again Paul!!
Tim
|
|
ffracer
New Member
Paul Smith
Posts: 22
|
Post by ffracer on Jan 6, 2004 20:28:57 GMT -5
So far I have used a ton of the Nut & Stud Pins including 1271 and 1272. As an example, each side of the front cover has 11 1271's. Also, I used the 1272's for the boths that join the halves of the crankcase.
Paul
|
|
ffracer
New Member
Paul Smith
Posts: 22
|
Post by ffracer on Jan 25, 2004 23:10:59 GMT -5
I have also been getting a lot of use out of the PE screw and bolt heads from Model Car garage. As an example, I have used a bunch of their slotted screw heads on the fulel injection metering unit.
|
|
|
Post by dickc24 on Feb 8, 2004 11:30:52 GMT -5
Will you suggest a source for RB Motion parts? The one I found has a limited number of parts. Thanks.
Dick Christ
|
|
|
Post by admin on Feb 8, 2004 13:40:06 GMT -5
I would email Robert Bentley directly at:
rbmotion@yahoo.com
Tell him that you found his info here!! ;D
I ordered nearly $200 in bolts and nuts from him and he gave me a nice discount.
Tim
|
|