ffracer
New Member
Paul Smith
Posts: 22
|
Post by ffracer on Jan 6, 2004 7:41:58 GMT -5
While not noted in the instructions, the keys for the ignition is included on PE sheet D. Look left and above center. The two are about 1/2 inch apart.
Paul
|
|
|
Post by Pappy50 on Jan 7, 2004 2:31:02 GMT -5
I have used these before in 1:24 scale. When you build this part, place the shaft of the key through the switch plate (R10} and put a tiny bit of superglue on the back. Let everything set up. Then cut off the shaft that sticks through the back and gently sand it flat. You can then glue it in place without trying to drill a hole in the dash. There is no reason to have a hole in the dash to stick the key in. Pete J.
|
|